There are two common styles of wood framing: balloon and platform. The main difference between balloon and platform framing is apparent at the floor lines. The balloon wall studs extend from the sill of the foundation all the way to the top plate of the second floor. The platform framed wall, on the other hand, is independent for each floor.

A slab-on-grade foundation is a type of foundation consisting of a structural concrete slab poured onto the ground, but usually, there is a layer of gravel and a vapor retarder between the ground and concrete. View illustration of a slab-on-grade installation. No accessible space exists in slab-on-grade construction. Slab-on-grade foundations are popular in areas where there is a high water table. For example, there are very few full basements in Southern Florida. In general terms, a slab-on-grade foundation is poured on the grade or ground. complements of InterNachi @ www.nachi.org

Common Structural Terms

In this section of the course, let's learn about some common terms or phrases that are used in the construction and building industry, particularly related to a residential building. Understanding construction terminology and knowing the purposes of building components and framing members (for example, studs, plates, load-bearing walls) will help a home inspector to do a better home inspection. Even though most building components are not readily accessible and are not readily visible to a home inspector performing a home inspection on an existing (already built house), it's important to know how buildings and homes are built. Sometimes defects can be seen by a home inspector, because the hidden, covered, or inaccessible system or component has a problem.

All electrical systems require a means of disconnection so that the service can be shut down quickly if any dangerous conditions exist. In this section, we will look at the types of disconnects, and the common problems that need to be reported.

Many people use the name Romex® when referring to type-NM cable. Romex® is a trademarked name that has come into common usage for referring to plastic-covered wires, but type-NM just means "non-metallic" and also applies to other cable styles.

This is often seen by the home inspector as the supply conduit to outside installations, such as air-conditioning compressors.

Wire types for North American wiring practices are defined by standards issued by Underwriters Laboratories, the Canadian Standards Association, the American Society for Testing and Materials, the National Electrical Manufacturers Association and the Insulated Cable Engineers Association.

The purpose of bonding is to ensure the electrical continuity of the fault current path, provide the capacity and ability to conduct safely any fault current likely to be imposed, and to aid in the operation of the over-current protection device.

The service-entrance cable SEC (blue arrow) is a line of service conductors (white arrows) located between the terminals of the service equipment (main disconnect) and a point usually outside the building, clear of building walls, where they are joined by a tap or splice (orange arrows) to the service drop or overhead service conductors (red arrows).

Valleys are weak spots in roofing systems. They have a lesser slope than the adjacent roof planes. They erode faster because water is directed into them. Inspectors must look not only at visible flashing, but also at the adjacent roof covering, at least a couple of feet on either side.