An automatic flue damper is an energy-saving device that closes off or restricts an appliance flue when the appliance is not operating and is in its “off” cycle. It traps residual heat in the heat exchanger after the burners shut off, and prevents the escape of conditioned air up the vent pipe.

Discharge, Loop and Air Gap

The dishwasher discharge hose should be connected to the waste tee or disposer inlet above the drain trap. It is recommended that the drain hose either be looped up and securely fastened to the underside of the counter, or be connected to an air gap.

The purpose of bonding is to ensure the electrical continuity of the fault current path, provide the capacity and ability to conduct safely any fault current likely to be imposed, and to aid in the operation of the over-current protection device.

What Is Grounding?

Generally speaking, the difference between grounding and bonding is: Grounding is a direct connection to the earth to aid in removing damaging transient over-voltages due to lightning. The purpose of bonding is to ensure the electrical continuity of the fault current path, to provide the capacity and ability to conduct safely any fault current likely to be imposed, and to aid in the operation of the over-current protection device. Properly bonding all metal parts within an electrical system helps ensure a low-impedance fault current path.

The service-entrance cable SEC (blue arrow) is a line of service conductors (white arrows) located between the terminals of the service equipment (main disconnect) and a point usually outside the building, clear of building walls, where they are joined by a tap or splice (orange arrows) to the service drop or overhead service conductors (red arrows).

Plumbing Vents

Depending on location, there are primarily two different types of plumbing vent flashing. The most common in northern climates is the neoprene or metal boot. In Florida and in many other southern states, a lead flashing, which also protects the plastic vent pipe from ultraviolet damage, is more common. The stack vent is provided for the waste stack. The stack vent is the extension of a soil or waste stack above the highest horizontal drain that is connected to the stack. This is the main commonly-observed pipe that is observed penetrating the sloped roof surface, and it may also be visible in the unfinished attic space. This is an inspection image of a stack vent pipe penetrating the roof covering surface.

Many roof problems are caused by issues with the framing and sheathing. In this section, we will focus on the defects that may be viewed from the exterior of the property. This is one of those cases where standing back and taking a good, hard look is better than getting "up close and personal" with the roof.