The minimum static pressure at the dwelling entrance for either public or private water service (as determined by the local water authority) should be 40 psi (276 kPa). The maximum static pressure should be 80 psi (552 kPa). When the pressure from the public water main or private well exceeds 80 psi, a pressure-reducing valve or regulator should be installed at the point where the water service pipe enters the dwelling. The pressure regulator should be installed immediately downstream of the main shut-off valve. To allow a continuous flow of water to the dwelling, the water pressure-reducing valve is designed to remain in an open position if the component fails.

Condensate drains from air conditioner coils, condensing furnaces, and heat-recovery ventilators should not drain directly into a DWV pipe. An indirect drain using an air gap should be installed. In some locations, the direct connection of a condensate drain line into a stack is not permitted, even with a trap. The potential danger is that sewer gases may enter the house through the condensate drain line. It is not a cross-connection problem, but it is unsafe and unhealthy. www.nachi.org & www.apollohome.com

An air gap in a drainage system is the unobstructed vertical distance of free space between the outlet of the waste pipe and the flood-level rim of the receptacle into which the waste pipe is discharging. As an example in a commercial restaurant, the air gap would be between the drainpipe of a salad bar and the floor sink or tub drain.

There are deep wells (more than 25 feet deep) and shallow wells (25 feet or less). A typical well pump can pull up about 25 feet of water. If the well is deeper than 25 feet, the pump will have to be installed at the bottom of the well to push the water up. Pumps are better at pushing than pulling.

Inspection of private water sources, such as a well, is beyond the scope of a home inspection.

Check for physical damage to the tank, particularly rust and corrosion on the bottom of the tank. Check for water marks on the floor of the tank. Check for a leaking TPR valve and discharge pipe is installed. The covers at the electric heating elements should not be disturbed. Corrosion can be found where the water pipes are connected to the top of the tank. The electricity or the fuel may be shut off. There could be scorching at the burner cover area. The heat rollout shield should be in place. The draft hood and vent connector are often loosely attached. All tanks should be accessible with at least 24 inches of working space around them.

A water heater tank should be installed inside a pan in locations in a dwelling where a leak from the tank could cause damage to the structure or property. The pan is intended to catch water leaks from the tank or associated connections, or condensate from the tank. The pan should be made of galvanized steel or other material approved for that use. Pre-fabricated aluminum and plastic pans are common and widely used. Aluminum and plastic pans may not be allowed by every authority having jurisdiction (AHJ) or code official because they are not made of galvanized steel, and some tank manufacturers require the use of a metal pan only.

Hot water boilers should be provided with expansion tanks. There are two types of expansion tanks designated for use with a residential boiler system. A non-pressurized tank is simply a cylinder filled with air set at atmosphere pressure. A pressurized tank is a sealed cylinder divided by a flexible diaphragm. An expansion tank provides space for the water to expand as it is heated, and it keeps the water pressure within the normal operating range while the boiler is working. Thank you www.nachi.org

The following are 13 requirements for a discharge pipe serving a TPR valve:

Temperature and pressure-relief (TPR) valves are safety devices installed on water heating appliances, such as boilers and domestic water supply heaters. TPRs are designed to automatically release water in the event that pressure or temperature in the water tank exceeds safe levels.